Airtek Air Dryer - Refrigerated,Heat Reactivated,Heatless,Filter,Magnum,Smart cycle| Full System Engineering co,ltd.

IHI Turbo Compressor

Airtek Airdryer

Piping Design

AIRTEK REFRIGERATED AIR DRYER ELLITE

	Elite Seris Designed to provide maximum reliability and consitent performance, Airtek's Elite Series Refrigerated Dryer uses virtually the same refrigeration design as the award-winning Smart Cycle dryer. The Elite Series is a good choice when pricing flexibility is necessary Airtek's Elite Series with the ''clean air package'' design provides cleaner air due to the increased efficiency of the filtration process achieved at lower temperatures.Additionally, significant pressure drop reduction is achieved because of the pre-separation of bulk contaminant's in the first stage of the built-in filter. Elite Series performance is unmatched by any competitor's dryer, at any price.
More Detail

AIRTEK-HEAT REACTIVATED DRYER

	Airtek heat reactivated desiccant air dryers use the adsorption method to remove moisture from compressed air.Pressure dew points ranging from minus 40 ํF (-40 ํC) to minus 100 ํF (-73 ํ C) are achieved by directing the flow of saturated compressed air over a bed of desiccant.The most commonly used desiccant is activated alumina, a spherically shaped, hygroscopic material, selected for its consistent size, shape and extreme surface to mass ratio.This physically tough and chemically inert material is contained in two pressure vessels commonly referred to as "dual" or "twin" towers.As the saturated compressed air flows through the bed of the "on-line" tower,its moisture content adheres to the surface of the desiccant.The dry compressed air is then discharged from the vessel into the distribution system.
More Detail

AIRTEK-HEATLESS AIR DRYER

	Airtek Heatless Dryers remove water vapor from compressed air through a process known as Pressure Swing Adsorption.Pressure dew points ranging from -40 ํF to -100 ํ F are attained by directing the flow of saturated compressed air over a bed of desiccant.The most commonly used desiccant is activated alumina, a spherical shaped, hygroscopic material, selected for its consistent size, shape and extreme surface to mass ratio. This physically tough and chemically inert material is contained in two separate but identical pressure vessels commonly referred to as "dual" or "twin" towers.As the saturated compressed air flows up through the "on line" tower, its moisture content adheres to the surface of the desiccant.The dry compressed air is then discharged from the chamber into the distribution system
More Detail

AIRTEK-REFRIGERATED AIR DRYER MAGNUM

	Airtek's patented Smart Cycle demand control reduces energy comsumption and maintains a true and constant dew point by loading and unloading or turning the refrigeration compressor on or off in direct response to the actual dew point temperature of the compressed air.The Smart Cycle control automatically adjusts for constantly changing operating conditions. The Smart Cycle computer eliminates hard wiring and contain a intuitive set of control instructions that provides for a level of precision performance not possible with the conventional systems of switches and relays.The controller simplifies dryer operation by automatically anticipating and executing the necessary operating steps. A nonvolatile EPROM controls all operating functions.The electronics are protected from voltage spikes and electrical shorts by board mounted relays.
More Detail

AIRTEK-REFRIGERATED AIR DRYER SMART CYCLE

	Airtek's award winning Smart Cycle and Cold Trap refrigerated air dryers come with Dual Mode operation. They can run in a full "cycling" mode or "non-cycling" demand mode.They deliver compressed air 2 times drier than conventional dryers with as little as half the energy.The standard control panel includes a digital Dew point Temperature Readout,with Diagnostic Display for alarms and protective shutdown annunciation.Common alarm and a dry contact signal:high dew point,low refrigerant,refrigeration system overload, sensor fault, and high/low refrigerant pressure.The panel also includes a Demand Drain Control and Mode Selector.Available options include:Control Centeer, dual hour meters, a PLC interface and a remote control panel. The dryers are available in two configurations.The SC or standard Smart Cycle package uses a high efficiency mechanical separator for liquid collection, whereas the CT or Cold Trap configuration utilizes a two-stage,combination Moisture Separator/Cold Coalescer to deliver virtually oil free compressed air.
More Detail

AIRTEK-FILTER

	Compressed Air Filers The atmosphere that surrounds us is contaminated with varying concentrations of hydrocarbons and solid particles.These contaminants, when compressed, form a pressurized concentration of contaminated gases, varnished oil and soiled water.Production downtime and unscheduled business interruptions are all too often caused by these concentrated contaminants.Airtek filters protect your air system by removing contaminants before they can do any damage.Keeping your compressed air clean,dry and oil-free is Airtek's specialty. Maintaining a dry air system,free of unwanted contaminants, results in long life and maximum efficiency of air operated equipment.The invertment is small in comparison to the long-term benefits. There are two types of Airtek JLA filters.The particulate filter removes solids;the coalescing filter removes liquid, aerosols and mists.
More Detail